ENIGMA II Programming Manual page 18

In normal case programming of the monitoring receiver unit can be done in serial port
(any of the COM ports or USB ports). After completing appropriate IP settings
programming can be done through Ethernet network as well. Please use EniTerm
software for programming. The programming steps are bellow:
1. Please start EniTerm software.
Note: PC programming provides access for all system parameter settings.
2. Choose the ET (settings) file according to the device what you want to program:
- CPM.et – CPM (receiver) programming
- LC.et – LC (telephone line card) programming
- RC.et – RC (radio receiver card) programming
- IP.et – IP Ethernet receiver card programming
3. In Communication / Port Settings menu set the communication port / IP address for
programming.
4. With Communication / Read Data menu you can read stored settings from receiver.
Note: Before reading LC telephone line card data, you should select number of the line
card in the pop-up window.
The highlighted firmware version means
the following (hexadecimal format):
C – 12 (2012)
A – 10 (October)
02 – 2 (Second day)
18