Table of Contents
Advertisement
58
C
5: B
HAPTER
ASIC
Putting a Call
on Hold
Music on Hold
Dialing a New Call
While on a Call
Answering a New
Call While on a Call
T
O
ELEPHONE
PERATION
It may take a few minutes for your headset to return from the
power-saving mode to the active mode when calls first come in, so your
telephone may not ring until the headset has returned to active mode,
and you may miss a call.
If you plan to not use the headset for a long time, 3Com recommends
that you set the mute and headset buttons on the amplifier to Off and
hang up the handset on your telephone. When you are ready to receive
calls again, set up the headset for receiving calls:
1 Pick up the handset on your telephone and set it on your desk.
2 Put on the headset.
3 On the amplifier, set the headset button to On.
To put a call on hold:
1 While you are on a call, press the Hold button. This message appears in
the Display Panel: Hold
2 To return to the call, press the Hold button again or press the appropriate
Access button.
If configured by the administrator, callers on hold hear music while they
wait.
You can put a call on hold, dial a new call, and toggle between the two
calls:
1 Press the Hold button.
2 Press one of the Access buttons not currently being used.
3 When you hear dial tone, dial the second call.
You can put your current call on hold, answer a second call, and then
toggle between the two calls:
1 When a new call arrives, press the Hold button to put the current call on
hold.
2 Press the Access button for the incoming call (its light will be flashing).
3 To toggle between the two calls, put the current call on hold and then
press the Access button for the call you want to resume.
Advertisement
Table of Contents
