[Center Staple Position] - Olivetti d-COLOR MF652 Operation Manual

17
Settings
[Punch Regist Loop Size
Adjustment]
[Punch Edge Sensor Ad-
justment]
[Vertical Punch (Z-Fold)
Position Adjustment]
[Horizontal Punch (Z-Fold)
Position Adjustment]
[1st Z-Fold Position Adjust-
ment]
[2nd Z-Fold Position Ad-
justment]
[Punch Unit Size Detect
Sensor]
[Post Inserter Tray Size Ad-
justment]

[Center Staple Position]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Center Staple Position]
If the staple position is not on the fold line on saddle-stitched paper, use this option to align the staple posi-
tion on the fold.
Copy after configuration, then repeat adjustments as required.
Settings
[Paper Size]
[Adjust Value]
Tips
- The above adjustment is available if Saddle Stitcher is installed on the optional Finisher.
- Adjust the half-fold position before adjusting the center staple position.
- Make adjustment while checking paper stapled at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
- For adjustments to put staples parallel with the left edge of paper, contact your service representative
for instructions.
17-14
Description
If the positions of the punch holes on the paper are not in parallel with the
paper edge, use this option to correct the obliquity of the paper to make
them parallel. For details, refer to page 17-18.
Use this option to adjust the sensor of the Punch function to detect the
edge of the paper. For details, refer to page 17-18.
If the positions of the punch holes on the paper are displaced vertically, use
this option to adjust the punch hole positions. For details, refer to
page 17-19.
If the positions of the punch holes on the paper are displaced sideways,
use this option to adjust the punch hole positions. For details, refer to
page 17-19.
Use this option to adjust the 1st Z-fold position. For details, refer to
page 17-20.
Use this option to adjust the 2nd Z-fold position. For details, refer to
page 17-20.
Use this option to adjust the sensor of the Punch function to detect the
edge of the paper. For details, refer to page 17-21.
If the size of the paper loaded into the post inserter is not detected correct-
ly, use this option to automatically adjust it so that it is detected correctly.
For details, refer to page 17-21.
Description
Select the size of paper that is used to adjust the staple position.
Enter an adjustment value between -10.0 and +10.0 mm by tapping [-] and
[+].
• [-]: Move the staple position to the left.
• [+]: Move the staple position to the right.
[0.0 mm] is specified by default.
d-Color MF752/652