Table of Contents
Advertisement
System Components
Video Camera Module
Camera module interface
board
Camera Link cable
(Sony Camera-compatible)
Camera cable
CCXC-12P02N (2 m, 6.6 ft)
CCXC-12P05N (5 m, 16.4 ft)
CCXC-12P10N (10 m, 32.8 ft)
CCXC-12P25N (25 m, 82 ft)
Install the board in a PCI bus slot in devices such as a computer. Select a commercially
available interface board compatible with the Camera Link feature. You can use either a board
that supports PoCL, or one that does not.
Use boards that support dual-power supply when you use the camera link configuration in
Medium, Full, or 80 bit with powered via PoCL.
Due to the performance of the board, the frame rate may become low according to lack of
processing capacity. To have this product output frames at the highest speed, use a board
corresponding to PCI-Express.
Performance may also be dependent on the host device (e.g., Computer), so consult the
dealer if images are not displayed properly.
This cable connects to the DIGITAL IF connector on the rear panel of the camera module.
Image/control signals are transmitted via this cable.
If there is support for PoCL, power is also supplied at the same time.
If you use a camera module interface board with support for PoCL, be sure to use a camera
link cable with support for PoCL. Use appropriate camera link cables for each specification
when you use the camera link configuration in Medium, Full, or 80 bit. Select a proper cable
as the maximum usable length of a cable differs due to the attribute of each cable.
Spotted noise may appear in a specific brightness in the window according to the attribute of
the cable. If this noise is an obstacle, shorten the cable.
C-mount lens
Camera adaptor
Use a lens appropriate
DC-700/700CE
for the pixel count of
the camera.
5
Tripod adaptor
VCT-333I (Insulated type)
Advertisement
Table of Contents
