Led Display - Christie Vivid Lite User Manual

LED Display

• Normal or abnormal operation of the internal parts is indicated by the 3
LED on the top of the projector. (See illustration on right)
• When the power cable is plugged into the socket, the POWER-ON
LED lights orange and the projector is in standby status.
• When the POWER button is pressed in standby status, the POWER-ON
LED lights green and the lamp comes on.
• When the POWER button is pressed while the lamp is on and "Power
Off" is selected on the confirmation screen, the POWER-ON LED
flashes orange and the lamp cools for about 2 minutes. The POWER-ON
LED then lights orange and the projector returns to standby status.
• In the event of an abnormality, depending on the fault, the POWER-ON, TEMP and LAMP LED light or flash red as
shown below and the power is automatically turned off. Follow the instructions below to remedy the fault.
LED Display
STAND-BY
POWER-ON TEMP. LAMP
(Power) (Temperature) (Lamp)
POWER-ON LED is on and
TEMP and LAMP LED are
flashing.
POWER-ON LED is on and
TEMP LED is flashing.
POWER-ON LED is on and
LAMP LED is flashing.
POWER-ON LED is on and
TEMP and LAMP LED flash
alternately.
POWER-ON, TEMP and
LAMP LED are all flashing.
On Flashing Off
Condition
Adjustment of internal
temperature malfunc-
tion.
Internal temperature is
abnormally high.
Lamp fails to light.
Fan failure
End of service life of
lamp.
As shown left, the LED light, flashes red, or is off.
Unplug power cable from socket to cancel display.
Wait until internal parts have cooled, then start up again.
If condition persists, take to place where purchased for
repairs.
If ventilation opening is blocked, remove blockage and
allow projector to cool.
Check air filter and if it is blocked with dirt, clean or
replace. (See page 29)
If condition persists, take to place where purchased for
repairs.
Wait 1 minute and start up again. At this time, fan rotates
for about 1 minute to cool internal parts. If condition
persists, take to place where purchased for repairs.
If rotation of the cooling fan is obstructed, remove
obstruction.
Unplug power cable from socket to cancel display.
If condition persists, take to place where purchased for
repairs.
Contact place where purchased and replace with a new
lamp. See page 30 for instructions on how to change the
lamp.
(LED Display)
STAND-BY
POWER-ON TEMP. LAMP
(Power) (Temperature) (Lamp)
Remedy
9