Maintenance Page Definitions - Grandstream Networks GXV3140 Application Manual

Advanced Settings/Ring Tone
Call Progress Tones
Default Ring Cadence

MAINTENANCE PAGE DEFINITIONS

Maintenance/Network Settings
Address Type
PPPoE
Static IP
Alternate DNS Server
Layer 3 Qos
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
Maintenance/Wifi Settings
Wifi Functions
Grandstream Networks, Inc.
Using these settings, users can configure ring or tone frequencies based on
parameters from the local telecom provider. By default, they are set to the North
American standard.
Frequencies should be configured with known values to avoid uncomfortable
high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of silence.
In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON
ms and a pause of OFF ms and then repeat the pattern. Up to three cadences
are supported.
This defines the ring cadence for the phone. The default setting is: c=2000/4000;
This selects the type of IP address assigned: DHCP, PPPoE or Static IP.
When PPPoE is selected, the user needs to enter the following: PPPoE Account
ID, PPPoE Password, PPPoE Service Name.
When Static IP is selected, the user needs to enter the following: IP address,
Subnet Mask, Default Gateway, Preferred DNS Server and Alternate DNS
Server.
This field sets the preferred DNS server for the user.
This field defines the layer 3 QoS parameter. It is the value used for IP
Precedence, Diff-Serv or MPLS. The Default value is 0.
This field contains the value used for layer 2 VLAN tagging. The Default value
is 0.
This assigns the priority value of the Layer2 QoS packets. The Default value is 0.
This parameter enables/disables the Wifi function. The default setting is set to
"No".
GXV3140 USER MANUAL
FIRMWARE VERSION 1.0.3.10
Page 37 of 117
Updated : 12/2009