Troubleshooting - Baumatic BVP460SS User Manual

Troubleshooting

For common problems and solutions please see the table below.
This table should only be regarded as a general guide. Errors
and faults are relative to individual circumstances.
Fault
All the lights on Overheating: circuit board
the command damage.
panel are
blinking.
The stop button Insufficient vacuum in the
light is flashing chamber. Minimum
and an alarm is vacuum power has not
sounding. been reached.
When switched Oil change warning due to
on, all the LED's having reached 2500
flash for 3 cycles.
seconds and an
alarm sounds
The cycle starts Pump thermal protection
but the pump intervention due to
does not overheating.
The appliance Energy shortage.
will not switch
on
Low vacuum
level in the bag
Possible causes
1) Irregular bag
soldering.
2) Dirty or perforated
bag.
3) Bag size not
suitable for the
size of the
product.
4) Insufficient pump
performance.
Solution
Turn the appliance off and wait for
about 15 minutes for it to cool
down and for the thermal
protection to be automatically
restored.
If, on switching the machine back
on, the same problem occurs call
the Baumatic Ltd Customer Care
Helpline to arrange for an engineer
to replace the power board.
Lid not pressed down at the
o
start of the cycle.
Lid of the container badly
o
positioned.
Lid seal worn or badly
o
positioned.
A technician is required to
o
check the air circuit, the
sensor board and vacuum
pump.
A technician is required to
o
check the correct electro
valve opening.
Vacuum pump in thermal
o
protection state: switch the
appliance off and wait for
15 minutes.
Technician required to change the
pump oil.
Switch the device off and wait for
15 minutes before turning it back
on.
Check the electrical connection.
1) Position the bag correctly.
Check the state of the
Teflon cover. Technician
required to change the
Teflon and check the
soldering resistance.
2) Change the bag.
3) Choose a bag where the
volume of the product is not
more than 2/3 of the
volume.
4) Technician required to
36