Table of Contents
Advertisement
Stopping a cycle in progress
o By pressing the stop button, an acoustic signal will
warn
interrupted. In this case, the appliance will not carry
out the soldering phase and the chamber will be decompressed.
o After the discharge phase all the LED's will revert to the initial
start-up mode.
Cleaning and maintenance
WARNING: PLEASE ENSURE THAT YOUR
APPLIANCE IS DISCONNECTED FROM
YOUR
ATTEMPTING TO CLEAN IT.
o Do not clean the appliance by pouring water onto it or spraying
water over it.
o Clean the containers separately with soap and water.
o Do not use abrasive products, detergents or soaps. Do not
scrape the surface with sharp objects.
o After washing the appliance, wipe over the area that you have
cleaned with a damp cloth and then dry it carefully and
thoroughly.
Cleaning the external surfaces
o The external surfaces of the vacuum-packer are made of
stainless steel and should be cleaned with a soft cloth or a
sponge and neutral detergent.
o After cleaning it is advisable to protect the external surfaces with
specific oil-based products for stainless steel.
During cleaning do not remove the matriculation plate. It
provides important information on the device for the service
centre.
o The control panel has "soft-touch" commands that do not use
protruding buttons. Therefore, an appropriate cleaning product
for glass surfaces is suitable for cleaning the control panel. Use
a soft cloth with only a little detergent and carefully dry.
you
that
the
cycle
MAINS
SUPPLY
will
be
immediately
BEFORE
21
Advertisement
Table of Contents
