Table of Contents
Advertisement
Final checks
Before switching the appliance on, it is recommended that you carry
out the following checks:
o If the vacuum-packer has been transported in a non-
vertical position e.g. on it's back, or it has been
tipped during installation, check the level of the oil in
the pump using the inspection hole.
1) Oil top-up cap
2) Pump
3) Oil level
4) Oil drainage cap
o Disconnect the appliance from the electricity supply.
o Dismantle the side inspection panel as shown above left.
o Check the correct oil level. If necessary, clean any drips and top
up the pump with SW40 oil.
o Check the appliance is correctly connected to the electricity
supply.
After carrying out these checks:
o Check the absorption with an ammeter.
o Carry out at least one complete cycle of vacuum-packing for
bags.
35
Advertisement
Table of Contents
