Osd - Function Setup > Scan Setup - Digital Watchdog PTZ39X User Manual

OSD -
FUNCTION SETUP > SCAN SETUP
1
FUNCTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
<PRESET SETUP>
<SCAN SETUP>
<PATTERN SETUP>
<GROUP SETUP>
<SCHEDULE SETUP>
BACK
EXIT
2
SCAN SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
SCAN NO.
1ST POS.
2ND POS.
SCAN SPEED
CLEAR SCAN
BACK
EXIT
By using the scan function, you can make the camera to move
between 2 preset positions repeatedly.
When the scan function runs, the camera moves from the
preset assigned as the 1st point to the preset assigned as the
2nd point in CW (Clockwise) direction. Then the camera moves
from the preset assigned as the 2nd point to the preset
assigned as the 1st point in CCW (Counterclockwise) direction.
In case that the preset assigned as the 1st point is same as the
Press
Near/Enter
preset assigned as the 2nd point, the camera turns on its axis
Key
by 360° in CW direction and then it turns on its axis by 360°
in CCW direction.
1
NOT USED
NOT USED
30/SEC
CANCEL
SCAN SETUP
2
2nd POS.
2. CCW direction
1. CW direction
SCAN NO.
1 ~ 8
Selects the scan number to edit. If a selected scan has not defined,
NOT USED is displayed in 1st position and 2nd position.
1ST POS. / 2 ND POS.
PRESET 1 ~ 128 / NOT USED
Set up the 2 position for scan function. If a selected preset is not
defined, UNDEFINED will be displayed as shown below.
SCAN SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
SCAN NO.
1 ST POS.
2ND POS.
SCAN SPEED
SCAN SPEED 1/SEC ~ 180/SEC
Sets the speed of the scan.
CLEAR SCAN CANCEL / OK
Deletes the current scan data.
28
1st POS.
1
PRESET 1
NOT USED
UNDEFINED
30/SEC