Osd - Function Setup > Scan Setup - Digital Watchdog x39 User Manual

OSD -
FUNCTION SETUP > SCAN SETUP
1
FUNCTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
<PRESET SETUP>
<SCAN SETUP>
<PATTERN SETUP>
<GROUP SETUP>
<SCHEDULE SETUP>
BACK
EXIT
Press
Near/Enter
Key
2
SCAN SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
SCAN NO. 1
1ST POS. NOT USED
2ND POS. NOT USED
SCAN SPEED 30/SEC
CLEAR SCAN CANCEL
BACK
EXIT
2 SCAN SETUP
By using the scan function, you can make the camera to move
between 2 preset positions repeatedly.
When the scan function runs, the camera moves from the
preset assigned as the 1st point to the preset assigned as the
2nd point in CW(Clockwise) direction. Then the camera moves
from the preset assigned as the 2nd point to the preset
assigned as the 1st point in CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point is same as the
preset assigned as the 2nd point, the camera turns on its axis
by 360° in CW direction and then it turns on its axis by 360°
in CCW direction.
2nd POS.
2. CCW direction
1. CW direction
SCAN NO.
1 ~ 8
Selects the scan number to edit. If a selected scan has not defined,
'NOT USED' is displayed in 1st position and 2nd position.
1ST POS. / 2 ND POS. PRESET 1 ~ 128 / NOT USED
Set up the 2 position for scan function. If a selected preset is not
defined, 'UNDEFINED' will be displayed as shown below.
SCAN SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
SCAN NO.
1 ST POS.
2ND POS.
UNDEFINED
SCAN SPEED
SCAN SPEED 1/SEC ~ 180/SEC
Sets the scan speed.
CLEAR SCAN
CANCEL / OK
Deletes the current scan data.
39
1st POS.
1
PRESET 1
NOT USED
30/SEC