Table of Contents
Advertisement
3
OSD -
FUNCTION SETUP > SCAN SETUP
1
FUNCTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
<PRESET SETUP>
<SCAN SETUP>
<PATTERN SETUP>
<GROUP SETUP>
<SCHEDULE SETUP>
BACK
EXIT
Press Near/Enter Key
2
SCAN SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
SCAN
NO.
1
1ST POS.
NOT USED
2ND POS.
NOT USED
SCAN SPEED
30/SEC
CLEAR SCAN
CANCEL
BACK
EXIT
2
SCAN SETUP
With the scan function, you can set the camera to move
between 2 preset positions repeatedly.
When the scan function runs, the camera moves from the
preset assigned as the 1st point to the preset assigned as the
2nd point in CW (clockwise) direction. Then, the camera
moves from the preset assigned as the 2nd point to the preset
assigned as the 1st point in CCW (counterclockwise) direction.
In case the preset assigned as the 1st point is same as the
preset assigned as the 2nd point, the camera turns on its axis
by 360° in CW direction and then it turns on its axis by 360°
in CCW direction.
2nd POS.
2. CCW direction
1. CW direction
SCAN NO.
1 ~ 8
Selects the scan number to edit. If a selected scan has not been defined,
NOT USED is displayed in 1st position and 2nd position.
1ST POS. / 2ND POS.
PRESET 1 ~ 128 / NOT USED
Set up the 2nd Position for scan function. If a selected preset is not
defined, UNDEFINED will be displayed as shown below.
SCAN SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
SCAN
NO.
1 ST POS.
2ND POS.
SCAN SPEED
SCAN SPEED
1/SEC ~ 180/SEC
Sets the speed of the scan.
CLEAR SCAN
CANCEL / OK
Deletes the current scan data.
1st POS.
1
PRESET 1
NOT USED
UNDEFINED
30/SEC
Advertisement
Table of Contents
