Chapter 2 Specifications - TDK-Lambda Genesys 10Kw Technical Manual

CHAPTER 2 SPECIFICATIONS

All specifications are subject to change without notice.
Contact factory for specific model availability.
1.Rated output voltage
2.Rated Output Current
3.Rated output power
1.Rated output voltage
2.Rated Output Current
3.Rated output power
1. Input voltage/freq.(range)
2.No of phase
3. Dropout voltage
4. Input current 180/360/432Vac
5. Power Factor
6. Efficiency at Low Line,100% load
7. Inrush current
8. Leakage current
9. Input Protection
10. Fuse
11. Input Overvoltage Protection
12. Phase Imbalance
1. Max. line regulation c.v
2. Max. line regulation c.c
3. Max load regulation c.v
4. Max load regulation c.c
5. Temp. drift c.v
6. Temp. drift c.c
7. Stability c.v
8. Stability c.c
9. Output noise p-p(20MHz) c.v
10. Ripple r.m.s 5Hz~1MHz c.v
11. Ripple r.m.s 5Hz~1MHz c.c (10kW)
12. Ripple r.m.s. 5Hz~1MHz c.c (15kW)
*Ripple and Noise at Full Rated Voltage & Load at 25C, Nominal Line. For models not listed use the ripple limit of the next higher voltage model. Per EIJ RC9002A
13. Rem. sense compensation/wire
1. OCP
2. OCP type
3. Knee point protection
4. Short circuit protection
5. Short circuit burn-in
6. Foldback protection
7. Foldback response time
8. OVP type
9. OVP programming accuracy
10. OVP adjustment method
11. OVP trip point
12. OVP response time
13. Max. OVP reset time
14. Output under voltage limit
15. Input under voltage protection
16. Over temp. protection
17. Phase Loss Protection
1. OUTPUT RATING (Duty Cycle Continuous Duty).
1.1 STANDARD MODELS - 10kW
V 7.5 10 12.5 20 25
A 1000 1000 800 500 400
kW 7.5 10.0 10.0 10.0 10.0
1.1 STANDARD MODELS - 15kW
V N/A N/A N/A N/A N/A
A
kW
2.INPUT CHARACTERISTICS
V 7.5 10 12.5 20 25
--- 208VAC (180-253); 400VAC (360-440); 480VAC (432-528), all 47-63Hz.
--- 3 Phase (Wye or Delta) 4 wire total (3 Phase and 1 protective earth ground)
V 175/355/425
A 10kw - 45/23/20
--- 0.88 Passive
% 77min for 7.5KW, 83 min for 10kW; 88 min for 15kW
A Not to exceed full rated Input current See Para. 2.4
mA 3.5 (EN60950-1) max.
--- 208 Circuit Breaker, 400/480 - Line Fuse
--- 400/480 Input Only
Unit shall not be damaged by line overvoltage with max. duration of 100uSec. Up to 120% of nominal AC input voltage.
% = < 5% on Three Phase Input
3. STATIC CHARACTERISTICS
V 7.5 10 12.5 20 25
---
0.1% of FS from Io min. to Io max
--- 0.1% of FS from Vo min. to Vo max
---
0.1% of FS from Io min. to Io max
--- 0.1% of FS from Vo min. to Vo max
--- +/-0.05% of Full Scale Over 8 hours, after 30 minute warm up, constant Line, Load & Temperature
--- +/-0.05% of Full Scale Over 8 hours, after 30 minute warm up, constant Line, Load & Temperature
200 (0.02% Full Scale)/Degree C
PPM/C
300( 0.03% Full Scale)/ Degree C
PPM/C
mV 60 60 60 60 60
mV 20 20 20 20 20
mA 5100 5100 2600 2600 1700 1700
mA – – – – –
V 1 1 1 1 1
4.PROTECTIVE FUNCTIONS
V 7.5 10 12.5 20 25
% 0~100
--- Constant current
--- None. No damage at knee point operation
--- Yes
--- Yes
--- Output shut down , manual reset by front panel OUT button.
S Less than 1
--- Inverter shut-down, manual reset by On/Off recycle or by OUT button
% 5% Full Scale
--- Adjust by front panel Voltage encoder and comm port.
V
0.05 to (1.02-1.05) x Rated Output Voltage
mS
Less than 10mS for Output to begin to drop.
S 7 from Turn On.
--- Preset by front panel or communication port. Prevents from adjusting Vout below limit.
Raises the Output good signal in case of output voltage is below limit.
--- Yes. Power supply shut down below low line.
--- Unit shall shut down when internal temperature exceeds safe operating levels. (Latched in Safe mode and
unlatched in auto mode).
Yes
83-530-000 Rev G
30 40 50 60 80
333 250 200 167 125
10.0 10.0 10.0 10.0 10.0 10.0
N/A N/A N/A 60 80
250 187.5
15.0 15.0 15.0
30 40 50 60 80
15kW - 64/32/27 All at full rated output power.
30 40 50 60 80
0.01% of FS from lo min. to lo max
0.05% of FS from lo min. to lo max
0.02% of FS lo min. to lo max
0.75% of FS from Vo min. to Vo max
60 60 75 75 100
20 20 20 20 25
100 80 67 50
– – – 100 100
1.5 2 3 3 4
30 40 50 60 80
10
100 125 150 200 250 300
100 80 66 50 40 33
10.0 9.9 10.0 10.0 9.9
100 125 150 200 250 300
150 120 100 75 60 50
15.0 15.0 15.0 15.0 15.0
100 125 150 200 250 300
100 125 150 200 250 300
100 125 135 135 200 200
25 25 25 35 35 60
40 32 20 20 16 13
100 50 50 20 20 20
5 5 5 5 5 5
100 125 150 200 250 300
400 500 600
25 20 17
10.0 10.0 10.2
400 500 600
37.5 30 25
15.0 15.0 15.0
400 500 600
400 500 600
200 300 350
60 60 60
10 8 7
10 10 10
5 5 5
400 500 600