Iax2 Config - ATCOM AT-530 User Manual

AT-530 User Manual
encrypt, default is common
DTMF Mode: DTMF signal sending mode: support RFC2833, DTMF_RELAY (inband audio)
and SIP info
RFC Protocol Edition:
communicate to devices (such as CISCO5300) using the SIP 1.0. Default is RFC 3261.
Enable Register:
server if disable register.
2.4.2

Iax2 Config

Setting page of public IAX server:
IAX Server Addr:
IAX Server Port:
Account Name:
number)
Account Password:
Local port:
Phone Number:
Voice mail number: If the IAX support voice mail, but your username of the voice mail is
letters which you can not input with the ATA , then you use the number to stand for your
username
Voice mail text: if IAX support voice mail, config the domain name of your mail box here.
Echo test number: If the platform support echo test , and the number is test form , the config
the test number to replace the text format The echo test is to test the woring status of
terminals and platform
Echo test text: echo test number in text format
Refresh time: IAX refresh time
Enable Register: enable or disable register
IAX(Default Protocol): Set IAX 2 as the default protocol , if not the system will choose SIP as
Current AT-530 SIP version. Set to RFC 2543 if the gate need to
Enable/Disable SIP register. AT-530 won't sent register info to SIP
Register address of public IAX server
Register port of public IAX server，default port is 4569
Username of your SIP account (Always the same as the phone
Password of your IAX account.
Signal port of local, default port is 4569
Phone number of your IAX account
12/50