Iax2 Config - ATCOM AT-640 User Manual

AT-640 User Manual
� Enable Session Timer: enable rfc4028 to refresh the SIP sessions.
� Answer With Single Codec: only answer the call with a certain Codec.
� Auto TCP: enable TCP transmission protocol when the length of message exceed
1300 byte.
� Enable URI Convert: convert # into %23 when sending URI.
� Enable Display name Quote: Set to make quotation mark to display name as the
phone sends out signal, in order to be compatible with server.
� Enable GRUU: Set to support GRUU.
� Enable Subscribe: Enable Subscribe: Overtime of resending subscribe packet.
Suggest using the default config.
3.2. 3.2.
3.2. 3.2.
Iax2 Iax2 Iax2

Iax2 Config

Config Config Config
Above is the IAX server configuration page
� IAX Server Addr:
�
IAX Server Port:
� Account Name:
phone number).
� Account Password: Password of your IAX account.
� Local port:
Phone Number:
�
� Voice mail number: If the IAX support voice mail, but your username of the
ATCOM TECHNOLOGY CO., LIMITED
Register address of public IAX server.
Register port of public IAX server，default port is 4569.
Username of your SIP account (Always the same as the
Signal port of local, default port is 4569.
Phone number of your IAX account.