Editing The Parameters Of The Effect; Storing An Effect With Your Own Parameters - Tascam TM-D1000 Operation Manual

9 - Effects
In some effect patterns, the effect type is fixed
as a dynamic processor and cannot be
changed.
1
Press the PARAM SEL
DYNAMICS indicator lights green.
2
Push the
DATA ENTRY
select the correct effect screen (1 or 2). The
effect screen number is shown at the top left
of the display:
2 - 0 1 C o n c e r t
- R E V E R B -
3
Press the ESCAPE/RECALL
The display will start to flash.
4
Turn the DATA ENTRY
effect to be used in this position.
5
Press to recall the effect.
ENTER
6
Push the
DATA ENTRY
ond effect position into which to select an
effect.
9.5 Editing the parameters of the
effect
1
Use the data editing knobs under the screen
to change the parameters above those knobs.
Note that as the knobs are turned, the abbreviated
parameter names are expanded to full names (for
instance, FB-Lv will be expanded to
Feedback Level).
2
Turn the
DATA ENTRY
more parameters.
25
TASCAM TM-D1000 Operations Manual
key until the EFFECT/
knob so that you
H a l l à ©
key.
knob to select the
knob to view the sec-
knob to view and set
3
To select the second effect, press the
ENTRY knob when the top right of the screen
Ã
shows (the down arrow symbol).
Pressing the DATA ENTRY knob once more will
take you back to the first effect unit.
9.6 Storing an effect with your
own parameters
1
Press and hold down the
the ESCAPE (STORE)
P a r a m e t e r s S T O R E
U 2 - 0 1 C o n c e r t
2
Turn the
DATA ENTRY
and holding it down to move the cursor
around the bottom line of the display.
3
Turn the
DATA ENTRY
edit the title character at the cursor position.
P a r a m e t e r s S T O R E
U 2 - 0 1 A l b e r t
Operating Tip
Use the key to change between upper-
SHIFT
case and lowercase letters when entering the
title of the effect.
4
Move the cursor to the left of the screen
(push and turn the
highlight the effect memory into which you
will store the new effect settings.
5
Press when you have finished enter-
ENTER
ing the name. The parameters will be stored
into the memory that you have selected.
DATA
key and press
SHIFT
key.
H a l l
knob while pushing it
knob (unpushed) to
H a l l
knob) to
DATA ENTRY
?
?