Tascam TM-D1000 Operation Manual page 22

mix as well as the monitor mix. If you are
working in a sound reinforcement or mixdown
application, you should take care not to use
the in-place solo mode, as this will destroy the
final mix.
To select the solo mode:
1
Press and hold down the
the OPTION key.
2
Turn the DATA ENTRY
line of the display shows
key and press
SHIFT
knob until the bottom
Setup
.
8 - Monitoring, etc.
3
Press and turn the
ENTER
knob until the bottom line of the display
SOLO Mode
shows
4
Press , and turn the
ENTER
knob to choose between the following pri-
mary solo modes (the secondary solo mode is
shown in parentheses):
In-Place SOLO (PFL)
In-Place SOLO (AFL)
PFL (In-Place Solo)
AFL (In-Place SOLO)
TASCAM TM-D1000 Operations Manual
DATA ENTRY
.
DATA ENTRY
22