Tascam TM-D1000 Operation Manual page 4

1.3.10MIDI IN & OUT
These MIDI connectors are used for control by an
external sequencer, etc., as well as for receiving
MIDI timecode and transmitting MIDI Machine
Control commands to external equipment.
See "MIDI Machine control" on page 29, "Loca-
tions" on page 30 and "MIDI control of the TM-
D1000" on page 32 for further details of MIDI func-
tions and the TM-D1000.
1.3.11DIGITAL OUTPUTS
There are two pairs of digital outputs provided:
and B . Each pair outputs the digital audio through
both an XLR and an RCA coaxial connector.
1.3.12DIGITAL INPUTS
Digital audio may be received through either the
XLR or RCA coaxial input of this digital audio input.
1 - TM-D1000 Operations Manual
1.3.13TDIF-1 A
This 25-pin D-sub connector is used to connect eight
input and eight output digital audio channels from
and to a DTRS recorder, or other suitably-equipped
digital audio multitrack device.
When making TDIF-1 connections between
units, you must always use genuine TASCAM
cables, or TASCAM-approved cables.
Although these cables appear similar to cer-
A
tain types of computer cables and use similar
connectors, the cables themselves are very
different, and the different electrical character-
istics of the cables can cause damage to the
equipment connected with the wrong cables.
If the use of cables other than TASCAM
cables causes or results in damage, the war-
ranty is voided.
TASCAM TM-D1000 Operations Manual
NOTE
4