Where Do The Busses Go - Tascam TM-D1000 Operation Manual

Hide thumbs Also See for TM-D1000:

Table of Contents

4.5 Where do the busses go?

As you can see from the above description, the L-R

stereo buss is not used for recording in the REC

modes. It goes straight out to the

(analog or digital) and to the

leled to the headphone output). You should therefore

use it as a monitor or cue buss when recording.

The behavior of the group outputs depends on the

number of group outputs which are being used in the

currently-selected buss function.

outputs

STEREO

MONITOR

buss (paral-

4 - Buss functions

Groups are always routed through to the TDIF-1 out-

put connector; the exact routing pattern is described

here.

• If both sets of groups (1-2 and 3-4) are in use, these

are assigned to the TDIF-1 output busses with the

same numbers, and are also "doubled" to 5-6 and

7-8 respectively.

• If only one set of groups is in use, it is always

group 3-4. This pair of groups is routed to all

TDIF-1 output busses, with four "copies" of this

pair going to 1-2, 3-4, 5-6, and 7-8.

These routing patterns are ﬁxed, and cannot be

changed.

TASCAM TM-D1000 Operations Manual

Table of Contents

Show Quick Links

Table of Contents