Installation; Access To Technical Compartment; Selection Of Installation Site; Installing The Appliance - Zodiac PF 11M Installation Instructions Manual

1.4 Installation

Do not pick up the unit by the outside case, use the base to lift the unit.
The installation and the hydraulic and electrical connections must be done to
standards in force.

1.4.1 Access to technical compartment

1.4.2 Selection of installation site

The appliance must be installed outdoors and must be surrounded by free space (see
§1.4.4).
 the heat pump must be installed at a minimum distance from the end of the pool so as to avoid
exposure to water splashes. The appropriate distance should be defined with reference to the
national electrical standards that apply in the country of installation.
 the heat pump must not be installed:
- near a source of heat or inflammable gas,
- near a road with the risk of water and mud splashes,
- facing a strong wind,
- with the blowing towards a window or nearby wall,
- with the blowing less than 4 metres from a permanent or temporary obstacle.
Any bad installation can cause serious material or bodily damage (and can cause
death).
Keep the appliance out of the reach of children.

1.4.3 Installing the appliance

 installed the 5 anti-vibration studs (supplied, see §1.1.2),
 put onto a stable, solid (concrete slab type) and level surface,
 preserve from risks of flooding due to condensation produced by the appliance whilst it is operating
(see §1.4.4)
Possibility of fixing the appliance to the ground, using the holes in the base of the appliance.
A diagram of drilling is available to the back of the packing box.
Fixing holes
EN
4