Table of Contents
Advertisement
1. Installation
1.1 Generals
Carefully read this manual before installing, performing maintenance on or
troubleshooting this device!
The symbol
indicates the presence of important information that must be taken into
account to avoid injurying people or damaging the device.
The symbol
indicates the presence of useful information serving as a guideline.
1.1.1 Cautions
The product must be installed by a qualified technician according to the
manufacturer's instructions and in compliance with local regulations. The installer is
responsible for the correct installation of the device and also for ensuring compliance
with local regulations in this respect.
The manufacturer will not be held responsible for any potential issues that may arise
due to failure to comply with local regulations pertaining to installation.
This device must be installed and serviced by certified professionals qualified for
electrical, hydraulic and refrigerating interventions.
Before working on the appliance, ensure that the power supply is disconnected and
secured, and that the function "priority heating" is disconnected.
Do not vent R410A into atmosphere: R410A is a fluorinated greenhouse gas, covered
by Kyoto Protocol, with a Global Warming Potential (GWP) = 1975 - (Directive of the
EC 842/2006).
Elimination or shunting of one of the safety leads automatically to the cancellation of
the guarantee, as for the replacement of parts by non-original parts.
1.1.2 General terms of delivery
Any equipment, even CARRIAGE and PACKING FREE, travels at the consignee's risk. The consignee
shall make reserves in writing on the carrier's delivery bill if he notes damage caused during the
transport (confirmation to be sent to the carrier within 48 hours by registered mail and
Acknowledgement of Receipt).
The appliance must be transported upright on its pallet in its original packaging.
If the appliance has been tipped over, express reserves in writing to the transporter.
Contents:
Supplied parts (in a bag in the technical compartment, see §1.4.1):
anti-vibration studs x5
+
+
half union Ø50 fitting to stick x2 + gasket x 2
+ M20 cable gland x1
+
+
2
Hide quick links:
Advertisement
Table of Contents
