Arming While Driving - Clifford Concept 650 Owner's Manual

G426P_2008-08.qxd 8/14/2008
➤ Press
chirps twice followed by a long chirp. Zone 2 is now
bypassed.
➤ Press
now bypassed.
➤
Press
four times followed by a long chirp. Zones 2 and 4 are now
bypassed.
➤
Press
five times followed by a long chirp. All input zones, except
the ignition, are now bypassed.
➤
Continued pressing of
Security Arming cycle over again.
note: Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.
➜

arming while driving

Your system can be armed while driving the vehicle. Simply press
running or while the ignition is on. The siren will chirp once and
then once more to indicate that the ignition is on. The security
system will not respond to any input except the door triggers and the
Failsafe
®
system will disarm automatically whenever the ignition is turned off.
The siren will chirp twice and the LED will stop flashing.
10
10:57 AM Page 10
a second time within five seconds: The siren
three times followed by a long chirp. Zone 4 is
a fourth time within five seconds: The siren chirps
a fifth time within five seconds: The siren chirps
on your transmitter for two seconds while the vehicle is
Starter Kill (if installed) will not be activated. The security
will begin the Multi-Level
© 2008 Directed Electronic All rights reser ved
24-Mar-10