Arming While Driving; Disarming - Clifford MATRIX 1 Owner's Manual

➤ ➤
Pressing the arm button a fourth time within five seconds:
The siren chirps four times followed by a long chirp. Zones
Two and Four are now bypassed.
➤ ➤
Pressing the arm button a fifth time within five seconds: The
siren chirps five times followed by a long chirp. All input
zones, except the ignition, are now bypassed.
note: Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.
➜

arming while driving

Your system can be armed while driving the vehicle! Simply press
on your transmitter for 1.5 seconds while the vehicle is
running, or the ignition is on. The system will chirp once and
then once more to indicate that the ignition is on. The system
will not respond to any input except the door triggers and the
starter interrupt relay (if installed) will not be activated. The
system will disarm automatically when the ignition is turned off.
The siren will chirp twice and the LED will stop flashing.
note: If programmed for the optional Vehicle Recovery
System (VRS) feature, arming with the transmitter will
arm the VRS feature. (See VRS section of this guide.)
➜

disarming

To disarm the system, press
the parking lights will flash twice. If the power locks are
8
. You will hear two chirps, and
© 2001 directed electronics, inc.