Clifford Concept 650 Owner's Manual page 83

G919730P_01-07.qxd 1/12/07 3:39 PM Page 36
PlainView 2 Valet Switch : A small two-button switch mounted some-
where inside the vehicle. It is used to override the alarm when a trans-
mitter is lost or damaged, or to enter or exit Valet mode.
Smart Self-Powered Siren : Noise generating device usually installed in
the engine compartment of the vehicle. It is responsible for generating
the "chirps" you hear, as well as the sound you hear while the alarm is
triggered. The siren has it's own built-in back-up battery, so even if a
thief were to cut all the wires the siren would continue to sound.
Transmitter : Hand-held remote control which operates the various
functions of your system.
This is what happens when the alarm
Trigger or Triggered Sequence
:
goes off or trips. The triggered response of your system consists of the
siren sounding and indicator lights flashing.
Warning Zone Response: Lighter impacts or movement close to the vehi-
cle will generate the Warning Zone response. It consists of a warning
siren blast or beep. (Requires either the Omnisensor or Dual Zone
Proximity sensor for this to operate.)
Zone : A zone is a separate input that the alarm can recognise as
unique. Each input to the system is connected to a particular zone. Two
or more inputs often share the same zone.
36
24-Mar-10