Avery Dennison Monarch 9825 Quick Reference page 9

L o a d i n g R i b b o n
Open the cover.
1.
Unlock the printhead by turning the
2.
retaining latch.
Lift printhead assembly using the
3.
printhead tab until the assembly locks
into place.
Push the deflector tab down.
4.
Slide the extra ribbon core on the take-
5.
up reel as far as it will go with the "This
End Out" writing facing out. Use your
empty ribbon core as the take-up core.
The take-up core only fits on the take-up reel one way.
Remove the new ribbon from the package. Do not wrinkle or crush
6.
the new ribbon.
Slide the ribbon onto the back reel as far as it will go. Carefully
7.
unwind a few inches of ribbon from the bottom of the roll.
Note: Make sure the "Monarch This
End Out" writing is facing out.
The ribbon roll only fits on the
reel one way.
Carefully feed the ribbon under both
8.
ribbon rollers and printhead.
Align the ribbon and make sure it is
9.
straight and centered throughout the
path.
10. Tape the ribbon to the take-up core.
Do not tape the ribbon to the take-up reel.
11. Rotate the take-up core until the leader is past the printhead.
12. Remove any slack in the ribbon by turning the take-up reel clockwise.
13. Hold the printhead assembly by the printhead tab while pressing
down on the printhead release.
14. Close the printhead by pressing down on the thumb well until you
hear it click into place. Close the cover.
Deflector Tab
Take-up Core
Take-up Reel
Ribbon
Rollers
7