Avery Dennison Monarch 9825 Quick Reference page 7

Loading Labels for the Optional Peel Mode
Peel mode must be purchased separately. In peel mode, the printer
separates the backing paper from the label. The next label is not printed
until the completed one is removed from the printer. Make sure the
printer is configured for on-demand mode and the correct supply type.
The minimum feed length is 1.5 inches for peel mode. Hold the leading
edge of peeled labels when printing on stock longer than six inches. You
must use non-perforated supplies for peel mode. Follow the steps for
loading supplies from the previous section. Then, follow these steps after
you close the printhead.
1. Remove the labels from the first 10 inches of the backing paper.
Press down on the exit cover tabs to open the exit cover on the front
2.
of the printer.
Feed the backing paper over the peel bar.
3.
Feed the backing paper through the lower opening of the exit cover.
4.
Close the exit cover. Pull down firmly on the backing paper to
remove any slack.
Peel
Bar
Low er
Opening
Tear
Edge
Backing
Paper
5