Avery Dennison Monarch 9825 Quick Reference page 11

C l e a r i n g J a m s
When you are printing and a jam occurs, the Fault light on the printer's
front panel blinks.
Turn off the printer and open the cover and printhead assembly.
1.
If necessary, remove the label roll and ribbon.
2.
Remove the jammed labels and reload the label roll.
3.
Close the printhead assembly and turn on the printer.
4.
5. Press Feed/Cut to position the supply under the printhead.
C l e a n i n g
Caution: Do not use sharp objects to clean the printhead or touch the
printhead. This may damage the printhead and require a
service charge.
The rate and frequency at which you print determines how often you must
clean the printer. You may need to clean the printhead, sensor, and
platen roller:
♦
if there is any adhesive build-up in the supply path.
♦
after printing approximately 3 rolls of thermal
transfer/thermal direct/linerless supplies or after each
ribbon.
♦
daily if your printer is in an excessively dirty, hot, or humid
environment.
♦
if you frequently receive supply error codes or when you
see voids or streaking in the print as shown.
Turn off the printer and open the cover and printhead assembly.
1.
Remove the label roll and ribbon (when cleaning the printhead).
2.
3. Press down on the exit cover tabs to open the exit cover on the front
of the printer.
Voids
Streaks
9