Avery Dennison Monarch 9825 Quick Reference page 6

Lay the label strip across the supply guide so that a few inches
7.
extend past the front of the printer. Tuck the supply under the nibs
and in between the die cut sensor.
8. For fan-fold supplies, lay the label strip over the supply holder and
across the supply guide so that a few inches extend past the front of
the printer. Tuck the supply under the nibs and in between the die
cut sensor.
Adjust the supply guides so they touch the supply. Push up on the
9.
supply lever to lock the supply guides into place.
10. Hold the printhead assembly by the printhead tab while pressing
down on the printhead release.
11. Close the printhead by pressing down on the thumb well until you
hear it click into place.
12. Close the cover.
13. Press Feed/Cut to position the supply under the printhead.
4
Die Cut Sensor
Nibs
Supply
Le ver