Avery Dennison Monarch 9825 Quick Reference page 8

When removing the backing paper, pull up across the saw-toothed
tear edge. Make sure the backing paper tears at the edge.
Close the printer's cover.
5.
6. Press Feed/Cut to position the supply under the printhead.
To load and use linerless supplies, refer to the Operator's Handbook.
A d j u s t i n g t h e W i d e / N a r r o w K n o b s
You may need to adjust the two wide/narrow knobs according to the width
of your supply. For supply that is more than two inches, adjust the knobs
to the wide setting. For supply that is two inches or less, adjust the
knobs to the narrow setting. For linerless supply, use the narrow setting
(knobs are up).
You must adjust both of the knobs to the same position.
If you experience ribbon smudging in cold, dry
environments, adjust the wide/narrow knobs to
the wide setting.
For wide supplies, push down and turn the
wide/narrow knobs clockwise with a screwdriver.
For narrow supplies, turn the wide/narrow knobs
counter-clockwise with a screwdriver until it
pops back up.
The adjustment is shown in the wide position.
6