Vent Diagrams - Heat & Glo TRUE-36G-IFT Installation Manual

F. Vent Diagrams
WARNING! Risk of Fire. This appliance requires a minimum of 24 inches of vertical venting before attaching any elbow to
the appliance. DO NOT attach elbow directly to the appliance.
General Rules:
• This appliance is approved for use with Hearth & Home Technologies DVP venting systems ONLY.
• When penetrating a combustible wall, a wall shield 昀椀restop must be installed.
• When penetrating a combustible ceiling, a ceiling 昀椀restop must be installed.
• This appliance requires a minimum of 24 inches of vertical pipe attached directly to the appliance starting collar before
attaching a 90 degree or 45 degree elbow.
• Horizontal termination cap should have a 1/4 inch downward slant to allow any moisture in cap to be released.
Top Vent - Horizontal Termination
One Elbow
TRUE-36 (NG/P), TRUE-42 (NG),
TRUE-50 (NG/P)
V Minimum H
1
2 ft 610 mm 7 in*
2.5 ft
762 mm 17 in
3 ft 914 mm 2 ft
1.2 m
4 ft 4 ft
1.5 m
5 ft 9 ft
1.8 m
6 ft 12 ft
2.1 m
7 ft 14 ft
3.0 m
10 ft 20 ft
6.1 m
20 ft 40 ft
After V = 2 x V ft Maximum
= 6 ft then H
1 1
V
+ H = 60 ft Maximum
1 1
*when used with approved termination caps
TRUE-42 (P)
V Minimum
1
10 in.
3 ft 914 mm
1.2 m
4 ft 4 ft
1.5 m
5 ft 9 ft
1.8 m
6 ft 12 ft
2.1 m
7 ft 14 ft
3.0 m
10 ft 20 ft
6.1 m
20 ft 40 ft
After V = 2 x V ft Maximum
= 6 ft then H
1 1
V
+ H = 60 ft Maximum
1 1
*when used with approved termination caps
Figure 4.8
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. Y • 6/23
Maximum
1
178 mm
432 mm
610 mm
1.2 m
2.7 m
3.7 m
4.3 m
6.1 m
12.2 m
H Maximum
1
254 mm
1.2 m
2.7 m
3.7 m
4.3 m
6.1 m
12.2 m
WARNING! Risk of Fire!
• TRUE-36(NG/P), TRUE-42(NG), and TRUE-50(NG/P) models
require a minimum of 24 inches of vertical venting before attaching
any elbow to the appliance.
• TRUE-42(P) model requires a minimum of 36 inches of vertical
venting before attaching any elbow to the appliance.
DO NOT attach elbow directly to the appliance.
H
1
V
1
23