Sun Microsystems Sun StorEdge A1000 Installation, Operation And Service Manual page 49

To Replace a Power Supply
1. Disconnect the power cord from the power supply you intend to replace.
You cannot remove the power supply without first disconnecting the power cord.
See . and
FIGURE 3-2
handle.
Removing and Replacing a Power Supply
FIGURE 3-4
2. Pull the locking handle down and slide the power supply out of the bay
( ).
FIGURE 3-4
3. Slide the new power supply into the bay.
Small rails on the power supply base fit into cut-outs in the chassis.
4. Push firmly until the power supply connector engages.
5. With the locking handle in the closed (up) position, connect the power cord.
The LED for the power supply should light green.
for the positions of the power connector and locking
FIGURE 3-3
Locking Handle
Chapter 3 Removing and Replacing Components 25