1.5 E
PS
ICD Group
PS Ring Group
Floating Extension no. for SVM
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analog Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
When the call is answered, if distinctive dial tones are enabled, dial tone 3 is heard, which continues until
the user goes on-hook. If the sensor call is not answered within a specified time, the call will be canceled.
It is possible to set a different ring tone pattern for calls received from each external sensor, to distinguish
between them.
Conditions
•
Hardware Requirement:
An external sensor and DPH card
•
Some devices may be unable to communicate correctly with the PBX. Confirm compatibility with the
manufacturer of a device before installing it.
•
After a sensor has been activated, the PBX will ignore any further alerts from the same sensor for the
duration specified by a timer. This timer can be set separately for each sensor.
•
As long as the previous sensor call is still being performed, any further alerts from the same sensor are
ignored.
•
The assigned sensor name and/or number are shown on the display of PTs and PSs when a sensor
call is received.
•
If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside
party), the call will be received at the original destination. (→ 1.6.6 FWD (Call Forwarding))
•
The following features cannot be used when a sensor call is received:
–
Alternate Receiving—Voice (→ 1.9.11 Intercom Call)
–
Hands-free Answerback (→ 1.8.1 Hands-free Answerback)
–
Consultation Hold/Call Hold (→ 1.3.2 Call Hold)
–
Call Transfer (→ 1.3.8 Call Transfer)
–
Executive Busy Override (→ 1.5.3 Executive Busy Override)
•
Sensor call information is output on SMDR.
Installation Manual References
2.5.1 DPH4 Card (KX-TAW84861)
80
Feature Manual
Destination
Availability