Daikin MCK75JVM-K Operation Manual page 31

Pleated fi lter replacement
If the Air-purifying filter lamp lights or flashes
1
Remove the front panel.
2
Remove the water tank.
3
Removed the UNIT1.
• Holding the UNIT1 by the handle, pull the UNIT1 upwards
and out of the unit.
Handle
(1)
Pull
UNIT1
4
Remove the deodorizing catalyst unit.
• Holding the deodorizing catalyst unit by the handle, pull
the deodorizing catalyst unit upwards and out of the unit.
Handle
(1)
Pull
Deodorizing catalyst unit
NOTE
● If the deodorizing catalyst unit is dirty, suck up dust with a vacuum cleaner. If the plate is dirty, wipe off dirt with a piece of cloth or tissue
moistened with water.
Page 28.
For stubborn dirt, wipe with a cloth moistened with a neutral liquid detergent. (Do not rinse in water.)
Cannot be rinsed in water
The pleated fi lter does not need
replacing until the Air-purifying fi lter
lamp lights or fl ashes.
Replace
5
Page 29.
Page 29.
(2)
Up
(2)
Up
WARNING
• Before performing maintenance, stop the
unit and unplug the power supply cord.
Replace the pleated fi lter with a new fi lter.
(1) Remove the used pleated fi lter.
• Release the pleated fi lter from the projections
(5 locations each) on the left and right of the
deodorizing catalyst unit (front side).
(2) Take a new pleated fi lter from the fi lter
storage area, remove it from its bag and
attach it to the deodorizing catalyst unit.
Attach the pleated fi lter with the white side
facing to the front.
• Fit the projections (5 locations) on the left and right
faces of the deodorizing catalyst unit into the holes
(5 locations) on the left and right of the pleated fi lter.
Projection
(5 each on left and right)
Pleated filter
Face the white
side to the front
Deodorizing catalyst unit
• Insert the pleated fi lter underneath the tabs
(4 locations) at the top and bottom of the deodorizing
catalyst unit.
Top and bottom
tabs (4 locations)
Holes
(5 each on left and right)
30