Print Font List; Hex Dump Mode; Network Reset / Factory Reset / Settings Reset - Brother HL-5440D Service Manual

1.4.2 Print font list

This function is to print the font list.
1.4.3 Change USB No. return value
When the operating system (OS) installed on the computer is Windows Vista
machine is connected to this computer using USB2.0FULL, the OS may not be able to obtain
the USB device serial number depending on the computer and USB device. If the serial
number cannot be obtained, the number of devices increases each time the device is
connected to the computer. This problem can be avoided by fixing the USB No. return value to
"0". The setting applied is reversed each time this mode is entered.
(The same function as that described in "1.3.11 Not-disclosed-to-users functions (function
code: 45) / Change USB No. return value" in this chapter)
The setting currently applied can be determined by pressing the [Go] button three times and
checking the LED status after several seconds.
LED display
Toner LED lights for one
second.
Drum LED lights for one
second.

1.4.4 HEX Dump mode

In this mode, the machine prints the print data sent from the computer as HEX (hexadecimal)
data without performing emulation. This mode is used to analyze any defects in the print data
that is sent.

1.4.5 Network Reset / Factory Reset / Settings Reset

Entering each of these modes resets the items summarized in the table below.
Data item
Counter information
Error log
Worker switches
User switches
Function setting
Macro
Font
MAC address
LAN setting
Emulation setting
*1
Resets only "WLAN enable".
Return value setting
Returns the serial number of the machine. (Default) →
Returns "0".
Returns "0". → Returns the serial number of the machine.
Network Reset
*1
5-36
®
and the
Factory Reset Settings Reset
Confidential