Disconnect Device - Brother HL-5440D Service Manual

IEC60825-1:2007 Specification
(For 220-240V models only)
This product is a Class 1 laser product as defined in IEC60825-1:2007 specifications.
The label shown below is attached in countries where required.
This product has a Class 3B Laser Diode which emits invisible laser radiation in the Laser
Unit. The Laser Unit should not be opened under any circumstances.
Internal laser radiation
Wave Length: 775 - 810 nm
Output: 15 mW max.
Laser Class: Class 3B
WARNING
Use of controls, adjustments or performance of procedures other than those specified
in this manual may result in hazardous radiation exposure.

Disconnect Device

CAUTION
This product must be installed near an electrical socket that is easily accessible. In
case of emergencies, you must disconnect the power cord from the electrical socket
to shut off power completely.
Wiring Information (U.K. only)
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362 with the
same rating as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover. If in any doubt,
call a qualified electrician.
Warning -This product must be earthed.
The wires in the mains lead are coloured in line with the following code:
• Green and Yellow: Earth
• Blue: Neutral
• Brown: Live
LAN Connection (Network models only)
CAUTION
DO NOT connect this product to a LAN connection that is subject to over-voltages.
viii
Confidential