Vacuum Unit Supreme 150 / Supreme 250 / Supreme Lcd Assembly Instructions; Fitting The Wall Bracket; Locating The Vacuum Cleaner On The Wall Bracket; Connecting The Machine - Nilfisk-Advance Supreme 100 Instructions For Use Manual

5 Assembly instructions Supreme 150 / Supreme 250 / Supreme LCD
Fig. 16
Fig. 17
Fig. 18
Exhaust

5.1 Fitting the wall bracket

Plan the positioning of the wall bracket so that there is
plenty of space above and below the area where the vac-
uum unit is to be located. Make sure there is a minimum
of 200 mm (7 in) free space below the dust container.
Mark the positions for all four screw holes with a pen or
similar. The diameter of the holes in the holder is 5 mm
(0.19 in). Select screws and, if necessary, wall plugs suit-
able for the type of wall concerned. Drill the four screw
holes.
Fit the wall bracket with the large opening pointing down-
wards, see Fig. 16. Then screw the holder fi rmly into place.
5.2 Locating the vacuum cleaner on
To facilitate the procedure, fi rst remove the dust container.
Free the container by pulling both handles outwards.
Then remove the container from the machine. To mount
the vacuum cleaner/motor chassis to the wall bracket - just
lower the chassis downwards so that the locking device of
the bracket will pass through the slot of the chassis Fig. 17.
Make sure the corresponding bracket on the machine is
held fi rmly in place by the wall bracket.
When removing the motor chassis from the wall bracket -
push the locking device towards you so it will release the
chassis and then lift the chassis up from bracket.

5.3 Connecting the machine

T
in the lower position and the exhaust pipe uppermost, Fig.
18. The fl exible hose is connected to the dust inlet at the
container of the cleaner. Push the hose in to the inlet at the
cleaner until the hose locks. Press the button on the hose
inlet downwards in order to remove the suction hose. The
fl exible suction hose acts as an adapter connecting the
vacuum unit with the pipe system.
NB! These connections must not be glued in case the
unit is handed in for service.
Position the central vacuum cleaner so that the exhaust
pipe can be kept as short as possible, maximum. 5
metres (16 ft). Take the surroundings into consideration
when positioning the exhaust. For this reason, you should
always fi t a muffl er.
For additional information concerning the assembly
and installation of the pipe system and low-current
lead, please refer to the separate assembly instructions
supplied with the pipe package.
Push the hose in to the inlet at the cleaner until the hose locks.
Press the button on the hose inlet downwards in order to remove
the suction hose.
Inlet
the wall bracket
he machine is connected with the fl exible suction hose
9