Athena C10 Communications Manual page 78

When the selection has been made the Programmed Setpoint menu is
enabled.
From the "Programmed setpoint" menu select New/Modify.
New Setpoint programs can be created and saved in this window or
already existing programs loaded from the Menu File, for any
modifications.
To create a new program:
1. select one of the items of the "Recover action after blackout"
parameter
2. select an item of the "time unit" parameter
3. select the number of segments which make up the program (minimum
1, maximum 6)
4. select the number of program cycles (from 0 to 9999, where 0
indicates infinite cycles) and enter the dead band value.
The decimals number, as already set in the Configuration – Config.
Configurator input, is also displayed.
To limit the Setpoint to the full programmed setpoint range select "SP
limit full range" from the Programmed setpoint menu.
For each segment set:
- time
- Setpoint value
- OP3 output state.
At the end of the setting press:
- Enter: to validate the data entered
Cancel: to quit the screen without saving
-
- Print: to print the window containing the data entered.
Or select Setpoint Profile from the menu.
78