Table of Contents
Advertisement
13.7
To clone several instruments
To clone several instruments from one that has been programmed with required
values, connect this instrument to the computer according to the instructions
above. Click on the tab 'Upload Cnf'. Click on the floppy disk 'icon' under the
heading 'Upload Configuration', to copy the instrument settings onto the screen.
Turn off the power to the instrument, un-plug it from its housing, plug-in a new
instrument and turn on the power. Click on the tab 'Download Cnf'. Click on the
floppy disk 'icon' under the heading 'Parameters and Configuration' to store the
screen settings into the instrument. Another new instrument can be plugged in
and the floppy disk 'icon' clicked again if required.
13.8
To store the screen settings as a file
To store the screen settings as a file, which can be saved as a
permanent record and used at a later date to copy into another controller,
click on 'File' and then 'Save', or click on the save 'icon' at the top of the
window. In either case, a 'Save as' window will open, with a highlighted
file name shown as *.M300 (for M300 controller), *.M400 (for M400
controller), *.c10 (for C10 or M10 controllers), *.M5000 (for M5000
controllers), etc. Over-type the * with the filename required, leaving the
.m300, .c10, etc. as the file extension, as in normal Windows
Click 'OK'. In any case the program sets automatically the suffix of the
corresponding instrument.
practice.
68
Hide quick links:
Advertisement
Table of Contents
