To create a new program:
1.
select one of the items of the "Recover action after blackout"
parameter
2.
select an item of the "time unit" parameter
3.
select the number of segments which make up the program (minimum
1, maximum 14)
4.
select the number of program cycles (from 0 to 9999, where 0
indicates infinite cycles) and enter the dead band value.
The decimals number, as already set in the Configuration – Config.
Configurator input, is also displayed.
To limit the Setpoint to the full programmed setpoint range select "SP
limit full range" from the Programmed setpoint menu.
For each segment set:
-
time
-
Setpoint value
-
OP3 output state.
At the end of the setting press:
-
Enter: to validate the data entered
Cancel: to quit the screen without saving
-
-
Print: to print the window containing the data entered.
Or select Setpoint Profile from the menu.To display the window of the
setpoint profile of the data entered in the New/Modify page program:
Press "Print" to print the window.
73