Installing The Scsi Adapter; Connecting The Storageloader To The Host; Power Up The Storageloader - Tandberg Data StorageLoader DLT VS160 Quick Installation Manual

Tandberg Data

Installing the SCSI Adapter

The StorageLoader makes use of a standard SCSI VHDC interface connector (also
known as a miniature SCSI connector). In general most "Adaptec compatible
HBA'a may be used". Please refer to the installation instructions supplied with the
SCSI host bus adapter for proper installation.
Connecting the StorageLoader to the
Host
The StorageLoader is designed to connect to the host with a supplied 68-pin VHDC
SCSI cable. The unit is designed with two rear connectors so that additional SCSI
devices may be daisy chained. If the StorageLoader is the last device on the
interface cable or if no other additional SCSI devices will be installed, the supplied
external terminator must be installed on the bottom SCSI connector.
Connect the other end of the SCSI cable to the host adapter installed inside the
computer.
Power Fuse Power cord
switch connection

Power Up the StorageLoader

Before connecting the StorageLoader to your host computer system you should
perform a simple self-diagnostic of the unit. This preparation requires power to the
StorageLoader. Go through the following steps to perform this test:
1. Plug a suitable power cable into the socket on the rear of the StorageLoader.
2. Plug the other end of the cable into a properly grounded electrical outlet. The
power ratings for the AC power is 90-264 VAC, 0,5 – 0,3 A, 47-63 Hz.
3. To perform the Power On Self Test (POST), turn on the StorageLoader.
StorageLoader Quick Installation Guide
Fan Back panel cover
plate
The StorageLoader's rear side
StorageLoader
Fan SCSI Ethernet
connectors port
11