Getting Started; What Is In The Box; Connecting The Phone - Allworx 9224 Phone Manual

1

Getting Started

1.1

What is in the box?

Check the contents of the box your phone came in. You should have:
·
Allworx 9224 phone and base
·
Handset with cord
·
Phone Functions Reference Card (this card slides between the base and back of phone)
·
This guide
Not included but also needed:
·
Ethernet cable to connect the phone to the network
·
Power supply: 24VDC, 400 mA (or a network connection with Power over Ethernet)
Optional Allworx Tx 92/24 Telephone Expanders can be purchased for your Allworx 9224 phone.
1.2

Connecting the Phone

Follow these steps to connect your phone (see the figure below):
1. Connect the handset to the Handset jack on the back of the phone using the coiled handset cord.
See icon on back of phone:
2. Plug one end of the Ethernet cable into the Network jack on the back of the phone. Plug the other end
into your Ethernet jack on the wall.
WARNING: Do not connect to an analog phone line.
3. A computer may be connected to the network through the phone's Computer jack.
4. If you are using Power over Ethernet (PoE), the power to the phone was supplied when you connected
the Ethernet cable. If this is the case, skip to step 6.
5. If you are not using PoE, obtain a power supply, connect the power cable to the phone, and then plug
the other end into an outlet. Using a surge protector is preferred.
6. Thread cables through the strain relief guide.
___________________________________________________________________________________________________________________
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2012 Allworx Corp, a Windstream company. All rights reserved. All other names may be trademarks or registered trademarks of their respective
Phone Guide – 9224
Revised: April 24, 2012
owners.
Page 1