Getting Started; What Is In The Box; Connecting The Phone - Allworx 9224 Phone Manual

1

Getting Started

1.1 What is in the box?

Check the contents of the box your phone came in. You should have:
•
Allworx 9224 phone and base
•
Power supply 24VDC, 400 mA
•
Handset with cord
•
Phone Functions Reference Card
•
This guide
Not included but also needed:
•
Ethernet cable to connect the phone to the network
Optional Allworx Tx 92/24 Telephone Expanders can be purchased for your Allworx 9224 phone.

1.2 Connecting the Phone

Follow these steps to connect your phone (see the figure below):
1. Connect the handset to the Handset jack on the back of the phone using the coiled handset cord.
See icon on back of phone:
2. Plug one end of the Ethernet cable into the Network jack on the back of the phone. Plug the other end
into your Ethernet jack on the wall.
WARNING: Do not connect to an analog phone line.
3. A computer may be connected to the network through the phone's Computer jack.
4. If you are using Power over Ethernet (PoE), the power to the phone was supplied when you connected
the Ethernet cable. If this is the case, skip to step 6.
5. If you are not using PoE, connect the power cable into the phone, and then plug the other end into an
outlet. It's a good idea to use a surge protector.
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
Phone Guide – 9224
© 2008 Allworx. All rights reserved
Version 1. Revised: October 31, 2008
Page 1