Table of Contents
Advertisement
1
Getting Started
1.1 What is in the box?
Check the contents of the box your phone came in. You should have:
•
Allworx 9204 phone and base
•
Handset with cord
•
Phone Functions Reference Card
•
This guide
Not included but also needed:
•
Ethernet cable to connect the phone to the network
•
Power supply: 24VDC, 400 mA (or a network connection with Power over Ethernet)
1.2 Connecting the Phone
Follow these steps to connect your phone (see the figure below):
1. Connect the handset to the Handset jack on the back of the phone using the coiled handset cord.
See icon on back of phone:
2. Plug one end of the Ethernet cable into the Network jack on the back of the phone. Plug the other end
into your Ethernet jack on the wall.
WARNING: Do not connect to an analog phone line.
3. A computer may be connected to the network through the phone's Computer jack.
4. If you are using Power over Ethernet (PoE), the power to the phone was supplied when you connected
the Ethernet cable. If this is the case, skip to step 6.
5. If you are not using PoE, obtain a power supply, connect the power cable to the phone, and then plug
the other end into an outlet. It's a good idea to use a surge protector.
6. Thread cables through the strain relief guide.
7. After applying power, the phone will initialize itself. You can watch its progress on the phone's screen.
A normal sequence would include:
a. Allworx Logo.
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx, a wholly owned subsidiary of PAETEC Holding. All other names may be trademarks or
Phone Guide – 9204
registered trademarks of their respective owners
Revised: September 1, 2010
Page 1
Advertisement
Table of Contents
