Getting Started; What Is In The Box; Connecting The Phone - Allworx 9102 Phone Manual

Congratulations! You're the new owner of an Allworx
for you to place and receive calls when using the Allworx System.
1

Getting Started

1.1 What is in the box?

Check the contents of the box your phone came in. You should have:
•
Allworx 9102 or 9112 phone
•
Power supply
•
Handset with cord
Not included but also needed:
•
Ethernet cable to connect the phone to the network

1.2 Connecting the Phone

We have taken all the challenge out of connecting your phone properly. Follow these steps to connect:
1. Connect the handset to the Handset jack on the back of the phone using the coiled handset cord.
2. Plug one end of the Ethernet cable into the Network jack on the back of the phone. Plug the other end
into your Ethernet jack on the wall.
WARNING: Do not connect to an analog phone line.
3. A computer may be connected to the network through the phone's Computer jack.
4. If you are using Power over Ethernet (PoE), the power to the phone was supplied when you connected
the Ethernet cable. If this is the case, skip to step 5.
5. If you are not using PoE, connect the power cable into the phone, then plug the other end into an outlet.
It's a good idea to use a surge protector.
6. After applying power, the phone will initialize itself. You can watch its progress on the phone's screen.
A normal sequence would include:
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007Allworx Corp. All rights reserved. Allworx is a registered trademark of Allworx Corporation. All other names may be trademarks or registered
Phone Guide – 9102 / 9112
trademarks of their respective owners.
Revised: October 10, 2007
®
9102 or 9112 VoIP phone. This phone will make it easy
Page 1