Machine Disassembly - Paramount Fitness PFT-200 Assembly Manual

M D
ACHINE ISASSEMBLY
If you need to disassemble your machine for any reason (i.e. maneuver the machine through small
doorway during installation), the diagram on the following page will show you the frame clamping
locations.
You will need the following tools:
DISASSEMBLY STEPS:
1. Remove the Rear Shroud.
2. If the weight stacks are installed, remove them from the machine. Also, remove the guide
rods.
3. Remove both cables.
4. Disassemble the Balance Bar from the Front Shroud by removing (2) bolts.
5. Remove the nuts and washers retaining the front shroud (5 top & 5 bottom).
6. Disassemble the top frame first by removing the (2) 1"-8 lock nuts from inside the front pivot
column tube. Then remove the 1/2"-13 socket head screws and lock washers (2) as shown.
Lift the top frame off of the pivot columns.
7. Remove the front shroud.
8. Remove the (4) 3/4"-10 lock nuts from the base frame. Lift to separate the Pivot Columns
and Support Columns from the machine.
9. To reassemble the machine, follow these steps in reverse order. Loosely assemble ALL frame
components and the front shroud before fully tightening any hardware. MAKE SURE that the
frame hardware is FULLY tightened using a 1/2" drive ratchet. Re-assemble the remainder of
the components.
•Ratchet (1/2" drive, minimum)
•1-7/16" Socket (1/2" drive, minimum)
•6" Extension (1/2" drive, minimum)
•1-1/16" Wrench (or socket)
•7/16" Wrench (for shroud removal)
•3/8" Hex Bit for 1/2" Drive Ratchet
•5/16" Hex Bit or allen wrench (balance bar removal)
18