Table of Contents
Advertisement
INSTALL WEIGHT STACK LABELS
1. Verify that there are 16 weight plates installed on each stack.
2. Wipe the front surface of the weights with isopropyl alcohol and allow to dry completely.
3. Remove the backing from the label. Vertically center the 10 lb. label on the top weight and align
the side of the label liner (front surface) with the outside edge of the pin hole in the weights.
4. Verify that the label strip is straight and then remove the liner. As the liner comes off the labels,
press and rub each label into place.
5. Allow the adhesive to cure for 48 hours. DO NOT attempt to "test" the integrity of the labels after
they have been installed.
6. The part number is B2173 for the 85 lb. label and B2173KG for kg. label.
Individual Labels
Align with outside
edge of pin holes
ASSEMBLE THE SELECTOR PINS
A
SSEMBLING THE
LINER
ATTACH LANYARD RING
11
M
ACHINE
Hide quick links:
Advertisement
Table of Contents
