Paramount Fitness PFT-200 Assembly Manual page 13

O
PTIONAL
E. Remove the pulley housing from the cap
plate by unscrewing it from the selector
bar.
F. Assemble the adder weight selector
mechanism, thrust washers, wave spring
washer, cover, and label plate to the cap
plate as shown.
G. Re-assemble the cap plate and guide
rod retainers to the machine.
H. Re-assemble the cables and pulleys to
the cap plate pulley housing along with the
selector pin lanyard.
I. Install the adder weight base supports
with the noted hardware. Make sure to
orient the angled cuts as shown.
J. Insert the square adder weight guide
rods into the base supports.
K. Slide the rubber washers and adder
weight assemblies onto the guide rods as
shown.
See following page...
I
NCREMENTAL
SEE TABLE ON PREVIOUS
PAGE FOR ITEM NUMBERS
PULLEY HOUSING
CAP PLATE
ASSEMBLY
SELECTOR BAR
4
13
A W
DDER EIGHT
15
14
13
10
2
SHOWN TRANSPARENT FOR CLARITY
1
3
5,6
S
YSTEM
12
11
9
CAP PLATE