Table of Contents
Advertisement
A
SSEMBLING THE
ASSEMBLE FEET TO BASE FRAME
INSTALL WEIGHT PLATES
1. Remove the rear panel held in place
by the three thumbscrews at the top.
2. If you ordered the optional adder
weight system, remove the adder
weight guide rods by pulling down on
the adder weight guide rod retainers
at the top of the guide rods. There is a
spring directly under the guide rod
sleeve. Retain it for re-assembly. (see
page 12).
3. Remove the bolt holding the guide rod
retainer. Slide the guide-rod retainer
up and allow guide rods to tilt toward
the rear of the machine.
4. Lift cap plate off of the guide rods.
5. Install the weight plates, 16 plates
per stack.
6. Re-assemble the cap plate, guide rod
retainers, incremental adder weight
assembly (if ordered) and rear panel.
M
ACHINE
10
GUIDE ROD RETAINER
CAP PLATE
GUIDE RODS
Hide quick links:
Advertisement
Table of Contents
