Disconnect power before accessing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
DRIVE MOTOR
Refer to page 4-23 for the procedure for ac-
cessing the drive motor.
1.
Unplug washer or disconnect power.
2.
Disconnect the 5-wire connector from the
drive motor.
3.
Set the ohmmeter to the R X 1 scale.
4.
Touch the ohmmeter test leads to the
following motor pins. For each measure-
ment, the meter should indicate approxi-
mately 6 Ω:
Pins 1 and 2
Pins 2 and 3
Pins 1 and 3
Electrical Shock Hazard
Pin 1
Drive Motor
Connector
5-8
INTERLOCK SWITCH
Refer to page 4-25 for the procedure for ac-
cessing an interlock switch.
1.
Unplug washer or disconnect power.
2.
Disconnect the wire connectors from ei-
ther of the interlock switch terminals.
3.
Set the ohmmeter to the R X 1 scale.
4.
Touch the ohmmeter test leads to the
two interlock switch terminals. The meter
should indicate an open circuit with the
actuator button pushed in, and a closed
circuit (0 Ω) with the actuator button out.
COM
N.C.
Actuator Button