Setting High-Speed Printing - Hitachi PXR-D Instruction Manual

calculating printing
preparation time
(See Section "1.5.3-4, Print
target detector )
3-49

Setting high-speed printing

3.10 Setting high-speed printing
1 Overview
¡When nozzle diameter 65
print line is set to 2 or 3 lines, three modes of HM, NM or QM can be selected
with the setting of particle use percentage: 1/1.
By selecting the mode, high quality printing result can be ensured according to
the linespeed.
HM mode
¡When nozzle diameter is 40
HM mode can be selected for 1-line print, QM mode can be selected for 2-line
or 3-line mode print.
1 Necessary conditions to perform high-speed printing
¡When all necessary conditions from Nos. 1 to 7 are satisfied, high-speed
printing HM, NM or QM mode can be selected.
No.
1 Character size
2 Print line
3 Line spacing
4 Barcode
5 Character orientation
Ink drop use
6
percentage
2 Type of high-speed print and number of vertical dots used
¡Number of vertical dots used in high-speed printing is shown in Table below.
¡When calculating printing preparation time, etc., pay attention to number of
vertical dots.
Number of vertical dots used when nozzle diameter is 65
Ink drop use rate
1/1
1/2
(Note) * When 2-line printing is set, settings of NM and QM will be the same.
m, with the character size setting is 5x7 dots, and
NM mode
m, with character size of 5x5, 5x7 or 5x8 dots,
Item
Conditions with 65
Character size of all print
items is 5x7.
Number of lines in all
columns is 2 lines or 3
lines.
line spaces in all columns are the same.
Bar code is not set for any print items.
Set value of character orientation is "0" or "1".
Ink drop use percentage: 1/1
No. of vertical dots
Type
used in 2-line printing
HM 14
NM 21 *
QM 21 *
28
Remarks
HM mode is equivalent to
particle use percentage
of 1/1.
In the 2-line print setting,
NM mode is equivalent to
ink drop use percentage
of 1/1.5.
If the line speed remains
the same, print width in
the NM mode will widen
by 1.5 times with respect
to HM mode.
m Conditions with 40
Character size of all print
items is the same.
Character size is any
one of 5x5, 5x7 or 5x8.
Number of lines for all
columns is the same.
Number of lines is any
one of 1 line, 2 lines or 3
lines.
m
No. of vertical dots used
3-line printing
21
28
35
42
m